Zebra Technologies TTP 8000 manual Sets A4 width, Sets Letter width

84

Default Parameter Settings

Fixed Document Mode

47	0	Default	Wall Compensation (mm)	DRV
	0	Min
	127	Max

When the printout is printed and cut, the presenter ejects about 50 mm of the page so that the customer can grab it. If the kiosk wall is thick, or if you just want a longer part of the printout to be visible, this parameter adds extra eject length.

<ESC>&P<47><50>

Adds 50 mm extra eject = about 100 mm in total.

Note • The resolution of the sensor is ± 3 mm so small changes in the parameter setting may not show.

Longer ejects are more accurate than shorter ones because acceleration and retardation of the rollers affects the eject less. Allow for ± 10 mm variations on short ejects.

48	208	Default	Paper Width (mm)	DRV
	58	Min
	216	Max

Sets the width of the paper loaded into the printer. This can also be used to get left and right margins, for instance if you load A4 paper but set the paper width to 170 mm you get a 20 mm margin on both sides of the page.

Note • The page width is not changed until the parameters are stored in the flash PROM with the command <ESC>&<4>. So you cannot change paper width within a page.

<ESC>&P<48><208><ESC>&<4>	Sets A4 width
<ESC>&P<48><214><ESC>&<4>	Sets Letter width

Note • We recommend you to set max 208 for A4 and max 214 for letter to allow the paper to wander a bit sideways without losing print.

P1003638-003 TTP 8000 Technical Manual 10/19/2009