Zebra Technologies TTP 8000 manual CR = Ignored, LF = Ignored

Default Parameter Settings

Print Setup

15 to 30	-	Default	Tab Stop
	1	Min
	255	Max

Stores 16 different TAB stop positions. The position is set in increments of 2.5-mm.

Tab position 255 sets a tab stop on the last position of the line. Use this if you want underline or reversed text to extend across the full paper width.

To set all tab stops at once, use Set Horizontal Tabs on page 43.

To move a single tab stop, use the set parameter command <ESC>&P. for example:

Example • <ESC>&P<15><10> set the first tab stop 25 mm from the left margin.

79

Default positions are one TAB on each cm; that is parameter values 4, 8, 12 etc. to 64.

31	20	Default	Pull Speed
	1	Min
	40	Max

Note • Vertical versions of the printer have n31 set to 2 on firmware versions up to 3.21 and to 1 for firmware versions 3.28 and above.

Sets the speed at which the paper is ejected / retracted. 1 = 45 mm/s, 40 = 1.8 m/s

33	0	Default	CR/LF Behavior
	0	Min
	4	Max

Note • v=0 is suitable for Windows, v=1 for UNIX, v=2 for DOS, and v=4 for Macintosh

Carriage Return and Line Feed can be interpreted in five different ways to suit different operating systems.

<ESC>&P<33><0>	LF = CR/LF	CR = Ignored
<ESC>&P<33><1>	LF = CR/LF	CR = CR
<ESC>&P<33><2>	LF = LF	CR = CR
<ESC>&P<33><3>	LF = LF	CR = CR/LF
<ESC>&P<33><4>	LF = Ignored	CR = CR/LF

10/19/2009 TTP 8000 Technical Manual P1003638-003