Broilmaster D3-1, D4-1 owner manual Troubleshooting, Problem Cause Solution

TROUBLESHOOTING

Although the manufacturer has attempted to ensure that your grill will operate properly and satisfactorily, sometimes problems do arise. The following troubleshooting guide lists several possible problems and their probable cause and solution.

Problem	Cause	Solution
Burner will not light.	Gas injector not inserted in venturi	Realign/engage gas injector with the venturi tube.
	tube.
	Clogged gas injector.	Remove gas injector from gas control assembly
		and clean.
	Obstruction in gas line.	For propane models, ensure gas valve on
		cylinder is OFF. Remove flexible hose and blow
		out any debris.
	Spider webs in venturi tubes.	Clean venturi tubes. See Maintenance Section.
	Misalignment of collector box and	Position electrode properly. Clean collector box.
	burner.
	Out of gas.	Refill LP gas cylinder. If natural model, turn on
		gas at source.
	Dead battery.	Replace with AA Alkaline battery.
Inadequate grill	Poor combustion.	Adjust air shutter.
temperature.
	Misalignment of venturi tube and	Realign/engage gas injector with the venturi tube.
	gas injector.
	Inadequate gas pressure.	Contact gas supplier for assistance.
	Incorrect orifice/valve setting.	Refer to gas conversion instructions in this manual.
Flames blow out.	Cold grill.	Preheat grill at least 5 minutes on HI with the
		grill lid closed.
	Misalignment of burner tube and	Realign/engage gas injector with the burner tube.
	gas injector.
	Poor combustion.	Adjust air shutter.
	Extreme wind.	Turn or shield grill.
Yellow flames.	Air shutter improperly set.	Open air shutter. See Maintenance Section.
	Spider webs in venturi tubes.	Clean venturi tubes. See Maintenance Section.
	Seasoning salts on burner.	Clean by washing burner with mild detergent.
	Oil film on burner.	Allow burner to operate on HI for 10-15 minutes.

B100691-0-0103 Page 21