Delta Electronics DOP-A Series, DOP-AE Series manual = Timetick, = Getlasterror, = Getsystemtime

	Chapter 4 Macro FunctionScrEdit Software User Manual
$1001 = 3A00H		Set starting Bit. Because the value of high byte and low
		byte will be exchanged when HMI sends command, even
		though the starting Bit is 3A when sending data, it is
		needed to input 3A00.
$1009 = 0A0DH		Set end Bit. Because the value of high byte and low byte
		will be exchanged when HMI sends command, even
		though the end Bit is 0D0A when sending data, it is
		needed to input 0A0D.
$1500 = PUTCHARS($1001, 20, 500)		Start to send data from $1001, the data length is 20
		bytes and the timeout setting is 500ms.
$1501 = GETCHARS($1121, 20, 500)		Receive the PLC response data after communication.
		The received data is stored in $1121, the data length is
		20 bytes and the timeout setting is 500ms.
$1050 = B2W($1125, 6)		Decompose received ACSII code into one BYTE and
		one BYTE from $1125 respectively and convert them
		into WORD format.
$1060 = A2H($1051)		Then, start to convert the WORD data into the value in
		hexadecimal format from $1051 and display the result in
		decimal format on the screen.

„ Others

Command		Equation	Descrption
TIMETICK	V1	= TIMETICK	Get the time from system startup to
			present
GETLASSERROR	V1	= GETLASTERROR	Get last error value
#	#V1		Comment
delay	delay V1		System delay
GETSYSTEMTIME	V1	= GETSYSTEMTIME	Get system time

Revision Apr. 30th, 2007, 2007PDD23000002 4-39