Delta Electronics DOP-AE Series, DOP-AS Series manual Word Double Word, „ Set Constant Button

Chapter 3 Element FunctionScrEdit Software User Manual
Property Description of Set Value Buttons
	Data Length	There are 16bits Word and 32bits Double Word two options.
		Minimum/Maximum:
		The user can set the minimum and maximum of input setting value
		to determine the range of input setting value.
	Data Format	It provides different kinds of data format for different data length:
			Word		Double Word
		1.	BCD	1.	BCD
		2.	Signed BCD	2.	Signed BCD
		3.	Signed Decimal	3.	Signed Decimal
		4.	Unsigned Decimal	4.	Unsigned Decimal
		5.	Hex	5.	Hex
		6.	Binary	6.	Binary
				7.	Floating
	Integral Digits	Use this option to determine the digit number of integer and decimal
		fraction. The digit number is not a real digit number value. It is only
	Fractional	the display format. The digit number will be a real decimal number
		only when the data format is selected as “Floating”.
	When the user has input the minimum and maximum value, after pressing OK
	button, HMI will examine the value by referring to the selected data length, data
	format, integral and fractional digits.
User Security Level	Use this option to set the user priority for pressing this element. Only the priority
	that is equal to or higher than the current setting can use this element.
Set Low Security	Use this option to force the current priority to be the lowest after the button is
	pressed. This can prevent the misoperation made by the user (operator).
InterLock Address	When InterLock Address is set to be ON or OFF (this is determined by the property
InterLock Level	of “InterLock Level”), this button can be enabled.
Before Execute Macro	If this option is set, when the user presses the button, the system will execute the
	command of this macro first and then perform the operation of this button. But, if
	the state of the button is not triggered by pressing the button (via macro or external
	signal), the command of this macro will not be executed.
After Execute Macro	If this option is set, when the user presses the button, the system will perform the
	operation of this button first and then execute the command of this macro. But, if
	the state of the button is not triggered by pressing the button (via macro or external
	signal), the command of this macro will not be executed.

„Set Constant Button

Table 3.2.5 Property description of Set Constant buttons

Property Description of Set Constant Buttons

After pressing this button on the screen, HMI will send the specified constant value to PLC corresponding register. It has the same function as Set Value button. The user can also specify the trigger mode to trigger the designated PLC address before or after writing the setting value.

Write Address	The address can be internal memory or the controller address. (Please refer to
	Table 3.2.2 Property Description of General Buttons.)
Text / Text Size	The user can set the text, text size, font and text color that provided by Windows®
Font / Text Color	to determine the text display on the element. (Please refer to Table 3.2.2 Property
	Description of General Buttons.)

3-10 Revision Apr. 30th, 2007, 2007PDD23000002