Delta Electronics DOP-AE Series, DOP-AS Series manual Property Description of Pipe 3 Element

		Chapter 3 Element FunctionScrEdit Software User Manual
Property Description of Pipe (1) / Pipe (2) Element
	Minimum Value		It is used to set the minimum and maximum capacity of the pipe
			element.
	Maximum Value
	Target		The user can decide if the target value displays or not by using
	Value		this option.
	Color
	Ranges (Enable		Please refer to the description of Low & High Region Color.
	range setting)
	Variable		When the target value and low & high limit is a variable value,
	target/range limits		the low limit address is Read Address+1, the high limit address
			is Read Address+2 and the address of target value is Read
			Address+3.
	When the user has input the target value, low & high limit, and minimum & maximum
	value, after pressing OK button, HMI will examine the value by referring to the
	selected data length and data format.
Low Region Color	This option is available and displayed in the property table only when the “Ranges”
High Region Color	option in the Detail Setup dialog box is selected. If the user sets the low limit value is
	30 and the color of low limit region is in green, and then set the high limit value is 70
	and the color of high limit region is in red, the pipe element will be shown as the
	figures below:
	When the value is 20			When the value is 50 When the value is 80

Property Description of Pipe (3) Element

It is used to connect to water pipe element. Pipe (3) element is shown as the figure below:

Pipe Gauge	Use this option to set the pipe gauge. The selectable range is from 1 ~ 5. The setting
	value 1 represents at least 13 pixels and the setting value 2 represents at least 26
	pixels and vise versa.

Property Description of Pipe (4) Element

It is used to connect to water pipe element. Pipe (4) element is shown as the figure below:

Revision Apr. 30th, 2007, 2007PDD23000002 3-25