HP IPv6 5400zl, IPv6 6200yl, IPv6 2900, IPv6 3500yl Stateful DHCPv6 Address Configuration, Router

IPv6 Addressing

IPv6 Address Sources

servers. These lifetimes cannot be reset using control from the switch console or SNMP methods. Refer to “Preferred and Valid Address Lifetimes” on page 3- 25.

Stateful (DHCPv6) Address Configuration

Stateful addresses are defined by a system administrator or other authority, and automatically assigned to the switch and other devices through the Dynamic Host Configuration Protocol (DHCPv6). Generally, DHCPv6 should be applied when you want specific, non-default addressing to be assigned automatically. For IPv6, DHCP use is indicated for conditions such as the following:

■address conventions used in your network require defined control

■static addressing is not feasible due to the number of nodes in the network

■automatic assignment of multiple IPv6 addresses per interfaces is needed

■automatic configuration of IPv6 access to DNS, SNTP, or TimeP servers

To implement stateful address configuration:

■The DHCPv6 server must be configured and accessible to the switch, either on the same VLAN or through an IPv6 router configured with DHCP Relay to support service requests from the switch.

N o t e	DHCPv6 relay may not currently be available in some IPv6 routers.
	■ DHCPv6 addressing must be enabled per-VLAN on the switch.
	Note that IPv6 router advertisements (RAs) can also include instructions to
	clients to use DHCPv6 resources. Refer to the documentation for your IPv6
	router.
	If you want to use DHCPv6 in a dual-stack environment, you will need both
	DHCPv4 and DHCPv6 server access. Also, further developments in DHCP
	services are likely to mean new capabilities affecting DHCPv6 deployments.

For related information, refer to:

■RFC 3315: “Dynamic Host Configuration Protocol for IPv6 (DHCPv6)”

■RFC 3041: “Privacy Extensions for Stateless Address Autoconfiguration in IPv6”

3-8