HP IPv6 2900, IPv6 6200yl, IPv6 5400zl, IPv6 3500yl Viewing the Current Telnet Activity on a Switch

IPv6 Management Features

Telnet6 Operation

Viewing the Current Telnet Activity on a Switch

Syntax: show telnet

This command shows the active incoming and outgoing telnet sessions on the switch (for both IPv4 and IPv6). Command output includes the following:

Session: The session number. The switch allows one outbound session and up to five inbound sessions.

Privilege: Manager or Operator.

From: Console (for outbound sessions) or the source IP address of the inbound session.

To: The destination of the outbound session, if in use.

For example, the following figure shows that the switch is running one outbound, IPv4 session and is being accessed by two inbound sessions.

ProCurve# show telnet

Telnet Activity

--------------------------------------------------------

Session	:	1
Privilege: Manager
From	: Console
To	: 10.0.10.140
--------------------------------------------------------
Session	:	2
Privilege: Manager
From	: 2620:0:260:212::2:219
To	:
--------------------------------------------------------
Session	: **	3
			The ** in the “Session: indicates the
Privilege: Manager
From	: fe80::2:101		session through which show telnet was
			run.
To	:

Figure 5-4. Example of Show Telnet Output with Three Sessions Active

5-7