HP IPv6 6200yl, IPv6 2900, IPv6 5400zl, IPv6 3500yl Configuring an IPv6 Address for an Sntp Server

IPv6 Management Features

SNTP and Timep

	Configuring an IPv6 Address for an SNTP Server
N o t e	To use a global unicast IPv6 address to configure an IPv6 SNTP time server
	on the switch, the switch must be receiving advertisements from an IPv6
	router on a VLAN configured on the switch.
	To use a link-local IPv6 address to configure an IPv6 SNTP time server on the
	switch, it is necessary to append %vlan followed immediately (without spaces)
	by the VLAN ID of the VLAN on which the server address is available. (The
	VLAN must be configured on the switch.) For example:
	fe80::11:215%vlan10
	Syntax:. [no ] sntp server priority < 1 - 3 > < link-local-addr>%vlan< vid > [1 - 7]
	[no ] sntp server priority < 1 - 3 > < global-unicast-addr> [1 - 7]
	Configures an IPv6 address for an SNTP server.

server priority < 1 - 3 >: Specifies the priority of the server ad- dressing being configured. When the SNTP mode is set to uni- cast and more than one server is configured, this value determines the order in which the configured servers will be accessed for a time value. The switch polls multiple servers in order until a response is received or all servers on the list have been tried without success. Up to three server addresses (IPv6 and/or IPv4) can be configured.

<link-local-addr >: Specifies the link-local IPv6 address of the destination device.

%vlan< vid >: Suffix specifying the interface on which the des- tination device is located. No spaces are allowed in the suffix.

<global-unicast-addr>: Specifies the global IPv6 address of the destination device.

[ 1 - 7 ]: This optional setting specifies the SNTP server version

expected for the specified server. (Default: 3)

5-10