HP IPv6 2900 Fe8021560fffe7aadc0 on Vlan 10, configured on the switch, 2001db821560fffe798980

IPv6 Management Features

SNTP and Timep

	For example, to configure link-local and global unicast SNTP server addresses
	of:
	■ fe80::215:60ff:fe7a:adc0 (on VLAN 10, configured on the switch)
	■ 2001:db8::215:60ff:fe79:8980
	as the priority “1” and “2” SNTP servers, respectively, using version 7, you
	would enter these commands at the global config level, as shown below.
	ProCurve(config)# sntp server priority 1
	fe80::215:60ff:fe7a:adc0%vlan10 7
	ProCurve(config)# sntp server priority 2
	2001:db8::215:60ff:fe79:8980 7
N o t e	In the preceeding example, using a link-local address requires that you specify
	the local scope for the address; VLAN 10 in this case. This is always indicated
	by %vlan followed immediately (without spaces) by the VLAN identifier.
	Syntax:. show sntp
	Displays the current SNTP configuration, including the
	following:
	Time Sync Mode: Indicates whether timesync is disabled or set
	to either SNTP or Timep. (Default: timep)
	SNTP Mode: Indicates whether SNTP uses the broadcast or
	unicast method of contacting a time server. The broadcast
	option does not require you to configure a time server address.
	The unicast option does require configuration of a time server
	address.
	Poll Interval: Indicates the interval between consecutive time
	requests to an SNTP server.
	Priority: Indicates the configured priority for the corresponding
	SNTP server address.
	SNTP Server Address: Lists the currently configured SNTP
	server addresses.
	Protocol Version: Lists the SNTP server protocol version to
	expect from the server at the corresponding address.

5-11