
IPv6 Addressing Configuration
Configuring a Static IPv6 Address on a VLAN
Statically Configuring A Global Unicast Address
Syntax:. [no] ipv6 address <
If IPv6 is not already enabled on a VLAN, either of these command options do the following:
■enable IPv6 on the VLAN
■configure a
■statically configure a global unicast address
If IPv6 is already enabled on the VLAN, then the above commands statically configure a global unicast address, but have no effect on the current
<
<device-id >: Enters a user-defined device identity.
<
After verification of uniqueness by DAD, the lifetime of a statically configured IPv6 address assigned to a VLAN is set to permanent, and is configured as a preferred address. (Refer to “IPv6 Address Deprecation” on page
The no form of the command erases the specified address and, if no other
To view the currently configured static IPv6 addresses
To view all currently configured IPv6 unicast addresses, use the following:
■show ipv6 (Lists IPv6 addresses for all VLANs configured on the switch.)
■show ipv6 vlan < vid > (Lists IPv6 addresses configured on VLAN < vid >.)
For more information, refer to “View the Current IPv6 Addressing Configura- tion” on page