HP IPv6 3500yl, IPv6 6200yl, IPv6 2900, IPv6 5400zl manual Vlan configured on the switch

IPv6 Management Features

SNTP and Timep

ip timep manual < ipv6-addr> [ interval < 1 - 9999 >]

Enable Timep operation with a statically configured IPv6 address for a Timep server. Optionally change the interval between time requests.

no ip timep	Disables Timep operation. To re-enable Timep, it is
	necessary to reconfigure either the DHCP or the
	static option.

N o t e	To use a global unicast IPv6 address to configure an IPv6 Timep server on the
	switch, the switch must be receiving advertisements from an IPv6 router on
	a VLAN configured on the switch.
	To use a link-local IPv6 address to configure an IPv6 Timep server on the
	switch, it is necessary to append %vlan followed (without spaces) by the VLAN
	ID of the VLAN on which the server address is available. The VLAN must be
	configured on the switch. For example: fe80::11:215%vlan10
	Syntax:. ip timep dhcp [ interval < 1 - 9999 >]
	ip timep manual < ipv6-addr ipv4-addr> [ interval < 1 - 9999 >]
	Used at the global config level to configure a Timep server ad-
	dress.
	Note: The switch allows one Timep server configuration.
	timep dhcp: Configures the switch to obtain the address of a
	Timep server from an IPv4 or IPv6 DHCP server.
	timep manual: Specifies static configuration of a Timep server
	address.
	< ipv6-addr>: Specifies the IPv6 address of an SNTP server. Re-
	fer to preceeding Note.
	[ Interval < 1 - 9999 > ]: This optional setting specifies the inter-
	val in minutes between Timep requests. (Default: 720)

For example, to configure a link-local Timep server address of:

fe80::215:60ff:fe7a:adc0

where the address is on VLAN 10, configured on the switch, you would enter this command at the global config level, as shown below.

5-13