HP IPv6 6200yl, IPv6 2900, IPv6 5400zl, IPv6 3500yl ProCurveconfig# ip timep manual

IPv6 Management Features

SNTP and Timep

	ProCurve(config)# ip timep manual
	fe80::215:60ff:fe7a:adc0%vlan10
N o t e	In the preceeding example, using a link-local address requires that you specify
	the local scope for the address; VLAN 10 in this case. This is always indicated
	by %vlan followed immediately (without spaces) by the VLAN identifier. For
	a global unicast address, you would enter the address without the %vlan suffix.
	Syntax:. show timep
	Displays the current Timep configuration, including the
	following:
	Time Sync Mode: Indicates whether timesync is disabled or set
	to either SNTP or Timep. (Default: Disabled)
	Timep Mode: Indicates whether Timep is configured to use a
	DHCP server to acquire a Timep server address or to use a
	statically configured Timep server address.
	Server Address: Lists the currently configured Timep server
	address.
	Poll Interval (min) [720]: Indicates the interval between
	consecutive time requests to the configured Timep server.

For example, the show timep output for the preceeding ip timep manual command example would appear as follows:

ProCurve(config)# sho timep

Timep Configuration

Time Sync Mode: Timep

TimeP Mode [Disabled] : Manual

Server Address : fe80::215:60ff:fe7a:adc0%vlan10

Poll Interval (min) [720] : 720

Figure 5-7. Example of Show Timep Output with an IPv6 Server Address Configured

Note that the show management command can also be used to display Timep server information.

5-14