3Com 10014298 manual Execute the debugging command in user view to debug PIM-SM

144CHAPTER 6: MULTICAST PROTOCOL

Execute the debugging command in user view to debug PIM-SM.

Table 157 Display and Debug PIM-SM

Operation	Command
Display the BSR information	display	pim bsr-info
Display the RP information	display	pim rp-info [
	group-address ]
Enable the PIM-SM debugging	debugging pim sm { all mbr
	register-proxy mrt timer
	warning	{ recv send } {
	assert graft graft-ack join
	prune	} }
Disable the PIM-SM debugging	undo debugging pim sm { all mbr
	register-proxy mrt timer
	warning	{ recv send } {
	assert graft graft-ack join
	prune	} }

Example: Configuring PIM-SIM

Host A is the receiver of the multicast group at 225.0.0.1. Host B begins transmitting data destined to 225.0.0.1. Switch A receives the multicast data from Host B by Switch B.

Figure 35 PIM-SM Configuration Networking

Host A		Host B
VLAN11	VLAN12	VLAN12 VLAN10

VLAN10VLAN11

VLAN10VLAN11

VLAN12

LSD

Configure Switch A

1Enable PIM-SM.

[SW7750]multicast routing-enable

[SW7750]vlan 10

[SW7750-vlan10]port Ethernet 1/0/2 to Ethernet 1/0/3

[SW7750-vlan10]quit

[SW7750]interface vlan-interface 10 [SW7750-vlan-interface10]pim sm

[SW7750-vlan-interface10]quit

[SW7750]vlan 11

[SW7750-vlan11]port Ethernet 1/0/4 to Ethernet 1/0/5

[SW7750-vlan11]quit

[SW7750]pim