Maintaining and Debugging the System 257

Perform this command in user view.

 

Table 285 Setting Daylight Saving Time

 

 

 

Operation

Command

 

 

Set the name and range of daylight saving

clock summer-time zone_name {

time

one-off repeating } start-time

 

start-date end-time end-date

 

offset-time

Remove the setting of the summer time

undo clock summer-time

 

 

By default, daylight saving time is not set.

Displaying System The following display commands are used for displaying the system state and the Information and State statistics information. For the display commands related to each protocol and

different ports, refer to the appropriate chapters.

Perform the following operations in all views.

Table 286 The Display Commands of the System

Operation

Command

 

 

Display the system clock

display clock

Display the system version

display version

Display the terminal user

display users [ all ]

Display the state of the debugging

display debugging [ interface {

 

interface-name interface-type

 

interface-number } ] [

 

module-name ]

 

 

Debugging the System Tasks for debugging the system are described in the following sections:

Enabling and Disabling Terminal Debugging

Displaying Diagnostic Information

Enabling and Disabling Terminal Debugging

The Switch 7750 provides various ways for debugging most of the supported protocols and functions.

The following switches control the outputs of debugging information:

The protocol debugging switch controls debugging output of a protocol.

The terminal debugging switch controls debugging output on a specified user screen.

Figure 61 illustrates the relationship between two switches.

Page 257
Image 257
3Com 10014298 Perform this command in user view, By default, daylight saving time is not set, Setting Daylight Saving Time