3Com 10014298 manual Entering Ethernet Port View, Enabling and Disabling Ethernet Ports

36CHAPTER 2: PORT CONFIGURATION

■Setting Flow Control for Ethernet Port

■Permitting/Forbidding Jumbo Frames on the Ethernet port

■Setting Ethernet Port Broadcast Suppression Ratio

■Setting the Link Type for an Ethernet Port

■Adding the Ethernet Port to a VLAN

■Setting the Default VLAN ID for Ethernet Port

■Copying a Port Configuration to Other Ports

■Displaying and Debugging Ethernet Ports

Entering Ethernet Port View

Before configuring the Ethernet port, enter Ethernet port view.

Perform the following configuration in system view.

Table 25 Enter Ethernet Port View

Operation	Command
Enter Ethernet port view	interface {Gigabit Ethernet}
	slot/subslot/port

The submodule on the fabric for the 4-slot chassis is always set to 1.

Enabling and Disabling Ethernet Ports

The following command can be used for disabling or enabling the port. After configuring the related parameters and protocol of the port, you can use the following command to enable the port.

Perform the following configuration in Ethernet port view.

Table 26 Enable/Disable an Ethernet Port

Operation	Command
Disable an Ethernet port	shutdown
Enable an Ethernet port	undo shutdown

By default, the port is enabled.

Setting Description Character String for Ethernet Port

You can use the following command to identify the Ethernet ports.

Perform the following configuration in Ethernet port view.

Table 27 Set Description Character String for Ethernet Port

Operation	Command
Set description character string for Ethernet	description text
port.
Delete the description character string of	undo description
Ethernet.

By default, the port description is a null character string.