Setting Terminal Parameters

27

Perform the following configuration in user view.

Table 17 Configure to Send Messages Between User Interfaces

Operation

Command

 

 

Configure to send messages between

send { all number type number }

different user interfaces.

 

 

 

The auto-execute Command is used to run a command automatically after you log in. The command is automatically executed when you log in again. See Table 18.

This command is usually used to execute the telnet command automatically on a terminal, which connects the user to a designated device.

Perform the following configuration in user interface view.

Table 18 Configure Automatic Command Execution

Operation

Command

 

 

Configure to automatically run the command

auto-execute command text

Configure not to automatically run the

undo auto-execute command

command

 

 

 

CAUTION: After applying the auto-executecommand, the user interface can no longer be used to carry out the routine configurations for the local system.

Make sure that you will be able to log in to the system in some other way and cancel the configuration before you use the auto-executecommand and save the configuration.

Telnet 10.110.100.1 after the user logs in through VTY0 automatically.:

[SW7750-ui-vty0]auto-execute command telnet 10.110.100.1

When a user logs on by VTY 0, the system will run telnet 10.110.100.1 automatically.

Displaying and Debugging User Interface

After creating the previous configuration, execute the display command in all views to display the user interface configuration, and to verify the effect of the configuration. Execute the free command in user view to clear a specified user interface.

Table 19 Display and Debug User Interface

Operation

Command

 

 

 

 

Clear a specified user interface

free user-interface

[ type ]

 

number

 

Display the user application information of the

display users [ all

]

user interface

 

 

Display the physical attributes and some

display user-interface [ type

configurations of the user interface

number ] [ number ]

[summary]

 

 

 

Page 27
Image 27
3Com 10014298 manual Perform the following configuration in user view, Displaying and Debugging User Interface