174CHAPTER 7: QOS/ OPERATION

The 20-Port 10/100/1000BASE-T and 20-Port 1000BASE-X-SFP I/O modules do not support this configuration.

Figure 46 Traffic Bandwidth

E3/0/8

GE3/0/1

GE3/0/2

VLAN2,

VLAN3,

1.0.0.1/8

2.0.0.1/8

To create this configuration:

1Define the time range 8:00 to 18:00.

[SW7750]time-range 3com 8:00 to 18:00 daily

2Define traffic rules for the packets of IP addresses 1.0.0.1 and 2.0.0.1.

[SW7750]acl number 2000

[SW7750-acl-basic-2000]rule 0 permit ip source 1.0.0.1 0.0.0.0

time-range 3com

[SW7750-acl-basic-2000]rule 1 permit ip source 2.0.0.1 0.0.0.0

time-range 3com

3Configure traffic bandwidth for the packets of IP addresses 1.0.0.1 and 2.0.0.1, view the configuration with the display command.

Enter QoS view.

[SW7750-Ethernet3/0/8]qos

[SW7750-qoss-Ethernet3/0/8]

Configure traffic bandwidth for the packets of IP addresses 1.0.0.1 and 2.0.0.1, view the configuration with the display command.

[SW7750-qoss-Ethernet3/0/8]traffic-bandwidth outbound ip-group 1

rule 0 20 60 40

[SW7750-qoss-Ethernet3/0/8]traffic-bandwidth outbound ip-group 1

rule 1 40 60 60

[SW7750]display qos-interface Ethernet3/0/8 traffic-bandwidth

Traffic Statistics

In this example, the IP address of the PC1 is 1.0.0.1 and the address of PC2 is

2.0.0.2.The switch is uplinked through the port GE7/0/8. Count the packets sent between 8:00 and 18:00 each day from the switch to PC1.

Page 174
Image 174
3Com 10014298 manual Traffic Statistics, Traffic Bandwidth