AT&T Door Phone Controller operation manual Option Selection

Refer to Appendix B for a detailed explanation of each of these options.

Any or all options may be reselected in any order.

The final step of the installation procedure is selecting options for your AT&T Door Phone Controller. The selection of these options must be done while in the Option Selection Mode. This mode lets you control such things as:

■Delay Before Door Ajar Call-Back

■Ring/Chime Cadence

■Ring/Chime Duration

■Door Unlock Code

■Door Unlock Duration

■Enable Door Code

■Door Ajar Mode

■Forced Disconnect Time-Out

■Reset Options to Factory Defaults

Follow the steps below to select options for the Door Phone Controller.

1.Select Option Selection Mode by setting position 8 of the Door Phone Controller DIP switch to the ON position (see Figure 1-1).

2.Once the DIP switch has been set, you must make con- nection to the door speaker by “hook-flashing” the phone (within 5 seconds) and entering “##3” on the telephone keypad (option selection mode is active as soon as you hear a distinctive dial tone).

3.Use Table 3-1to make each option selection.