AT&T HS-8211 user manual Batteries, Charging the Handset Battery Pack

Page 14

BATTERIES

Charging the Handset Battery Pack

This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours.

The battery pack needs charging when:

A new battery is installed in the handset.

The phone beeps twice when you press P.

The phone light flashes slowly.

Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours.

You can keep the battery fully charged by returning the handset to the base after each use.

If you repeatedly get a low battery indicator, even after eight hours of charging, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully:

Use only Replacement Battery 3301 (SKU# 91076).

Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause harm.

Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

Observe proper polarity orientation between the battery and battery charger.

13

Image 14
Contents MHz Cordless Telephone HS-8211 Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Install the handset battery InstallationBefore You Install Attach the belt clip to the cordless handset optional Check for dial tone Table/Desk InstallationSet the dial mode Position the wall mount adapter on the base Wall InstallationConnect the telephone line cord Connect the power cord Follow Steps 3-5 in Table/Desk Installation Mount the base on the wallTelephone Operation Telephone Operation Handset Ringer Style Ringer Off/Battery SaveTemporary Tone Dialing Headset Jack Operating RangeTelephone Memory Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack If the phone doesn’t work at all, check these items first If the phone does not ring when you receive a callCase of Difficulty If you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone