AT&T HS-8211 user manual Telephone Operation

Page 9

TELEPHONE OPERATION

Handset Volume

Adjust volume of what you hear through the handset.

Make or

Answer a Call

Lift handset from base

— OR —

Press Pand wait for light to go on steadily.

Flash/

Call Waiting

Access special telephone company subscriber services.

Redial

Follow the instructions under “Make or Answer a Call,” then press Rto call the last number dialed (up to 24 digits).

End a Call

Place handset

in base

— OR —

Press O.

Exit

programming.

Cancel a page.

Change Channel

Switch to a

clearer channel.

On steady:	Blinking:
Handset in use	Programming mode
Flashing:	Flashing slowly:
Line ringing	Battery low

8

Image 9

Contents Part 1 Important Product Information MHz Cordless Telephone HS-8211Advanced American Telephones. All rights reserved Contents Installation Before You InstallInstall the handset battery Attach the belt clip to the cordless handset optional Table/Desk Installation Set the dial modeCheck for dial tone Wall Installation Connect the telephone line cord Connect the power cordPosition the wall mount adapter on the base Mount the base on the wall Follow Steps 3-5 in Table/Desk InstallationTelephone Operation Telephone Operation Ringer Off/Battery Save Temporary Tone DialingHandset Ringer Style Operating Range Headset JackTelephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels