AT&T E5938B, E5939B user manual Remote access, Stop

1. Dial your telephone number from any touch tone phone.

2. When system answers, enter a two-digit remote access code (19 unless you have changed it).

3. Enter remote commands (see list at right).

4. Hang up to end call and save all undeleted messages.

NOTE: If you pause for more than 10 seconds during remote access, you will hear a help menu listing all features & commands. If you issue no command for another 20 sec- onds, the call will end automati- cally.

Answering system operation

Remote access

Atwo-digit security code is required to access your answering system from any touch tone phone. This code is 19 by default; see page 35 to change it.

Play all messages	Press to hear all messages.
1
Play new messages	Press to hear new messages.
2
Delete the message	Press during playback to delete cur-
3	rent message. Press 3 twice to delete
33	all old messages while in remote
	access idle mode (message not being
	played).
Repeat or go back	Press during the caller’s message
4	to repeat the message. Press during
	the beginning of the day and time
	announcement to go back to the pre-
	vious caller’s message.
Stop	Press to stop any operation (stop
5	playback, stop recording).
Skip to next message	Press to skip current message and
6	advance to next message.
Review announcement	Press to review current outgoing
#7	announcement.
Record announcement	Press * 7, wait for beep, then begin
*7to begin recording	speaking. Press 5 to stop record-
5to stop recording	ing and hear playback of the new
	announcement.
Record memo	Press 8, wait for beep, then begin
8to begin recording	speaking. Press 5 to stop recording.
5to stop recording
Review remote access	Press # 9 to review remote access
code	code.
#9
Change remote access	Press * 9 to change remote access
code	code, then enter the desired remote
	access code from 10-99.
*9

39