Cloning Mode: Cloning Using the Cloning Cable | |
|
|
Cloning Using the Cloning Cable
1.From the Clone menu, scroll to select Duplicate Radio and press under Select. The fol- lowing screen is displayed indicating the target radio must now be connected to the source radio to be cloned using the cloning cable.
2. Connect the cloning cable to both radios.
NOTE: The target radio must be turned on, but does not need to be in cloning mode.
3.Press under Clone to start the cloning. The “Cloning in Progress” screen is displayed followed by the “Cloning Successful” screen. If a problem occurs the “Cloning Failed” screen appears.
4.After cloning is completed, the target radio displays the following screen.
5.Turn target radio off then back on again to use.
6.Press under Reset to exit the Clone menu.
November 2008 |