CHARGING THE SUPERTOOTH II
SuperTooth II can be charged in a car using the SuperTooth II Car Charger or at home using the Wall charger.
1.Connect the charger’s plug into the Charger Input of SUPERTOOTH II.
Charge Indicator Status:
•Red = Low battery
•Steady Green = Fully charged
•Alternate Red/Green = indicates charging
2.When fully charged, disconnect the charger.
Bluetooth Indicator Status:
•Blinking Blue = standby (when Swivel Arm is open to 55º to 210º positions).
TURNING ON/OFF THE SUPERTOOTH II
1.To turn SuperTooth II on, just flip up the Swivel Arm at 55º to 210º positions. The Bluetooth indicator will glow (blue blink). This indicates that the kit is ready (standby mode).
Note: Before using this car kit, the user must pair the SuperTooth II with his phone (refer to PROCEDURE OF PAIRING TO THE MOBILE PHONE).
2.To turn SuperTooth II off, just flip down the Swivel Arm to 0º position. The Bluetooth Indicator will become red then will turn off after a second.
ADDITIONAL ACCESSORIES go to www.blueant.com.au
1.Extra SunVisor clips
2.Wall Charger
3.Car Charger
4.Earpiece Headset
5