Switching the Headset ON/OFF

X5 Stereo Bluetooth Headset

zTo switch on the Headset, click and hold ON/OFF for 3-4 seconds until LED flashes blue rapidly and then release button.

zTo switch off the Headset, click and hold ON/OFF for 3-4 seconds until LED flashes red rapidly and then release button.

Pairing Headset with Bluetooth Devices (Phone, PDA)

zBefore pairing the X5 Headset with Bluetooth Devices, please make sure the host device supports any of the following profiles : A2DP, AVRCP, Headset/Handsfree profiles.

zWith battery mounted onto Headset, click and hold Vol Up & ON/OFF buttons together for more than 4 seconds. When LED starts to flash red and blue alternately, release the two buttons. LED will then flash red and blue continuously. This pairing mode will last for 1 minute and if no pairing is made within this period, the Headset will return to standby mode.

zManipulate the buttons or menus of Bluetooth device to complete pairing (Refer to device’s manual as the instructions may differ from device to device). Check if the X5 or corresponding ‘Bluetooth Address’ is displayed in the list of searched devices. If device is not found, repeat pairing procedure.

zWhen prompted to enter PinKey, enter 1234 which is the fixed PinKey for X5 Stereo Bluetooth Headset.

zThe Headset can be paired with up to 10 different devices. Pairing is done just once and not every time a different device is used.

zFor pairing of Headset with Audio Streamer, refer to the instructions on page 15.

This following is an example of how to pair with your phone/PDA. This procedure may differ depending on the mobile phone you’re using.

1.Put your X5 into Pairing mode as above.

2.Turn Bluetooth ON in your mobile phone or PDA(Refer to your Phone User Guide) and perform a device discovery to Search/Add the X5

3.When devices are displayed, select the X5. Enter Passkey “1234”.

4.Set the X5 as a trusted/authorized device, if it is an option in your phone.

5.Finish and exit. (Refer to your Phone User Guide for any additional steps) 6.To pair up more devices; Repeat steps 3-6 for each device you want to

pair.

Note: Some devices require you to pair once for High Quality Audio/A2DP profile and again for Handsfree/Headset profile, E.G HP 6515. Other phones require pairing only once but will enable both profiles E.G Samsung D600, O2 XDA Atom)