BlueAnt Wireless X5 manual Reconnecting Audio Streamer with Headset

16 X5 Stereo Bluetooth Headset

Using Audio Streamer with Headset for Stereo and Voice Applications

zTo use the Headset with PC for stereo and voice application, first make sure the X5 Headset and Audio Streamer are connected. Plug the USB microphone into the USB port of the Headset. Connect the Audio Streamer into the PC by plugging one end of Y-cable into the Audio Streamer and the other two ends into audio in and mic. jacks as shown in the diagram below.

zAt this stage, the connection between Headset and Audio Streamer is in stereo mode. The Microphone is not active.

zTo use the microphone for 2 way voice communication, the mode must be switched to voice mode. To switch from Stereo to Voice mode, click the ON/OFF button of X5 Headset once.

zRun your VOIP application and start enjoying wireless 2 way voice communications.

zIf you have been listening to music via stereo mode, then on an incoming VOIP call, you will hear bell tone intermingled with sound of music. To switch to voice mode, first stop or pause the music on the computer and then click ON/OFF button of Headset once to enter into Voice mode.

zTo switch over to Stereo mode to listen to music after ending Voice call, click MFB button of the X5 Headset once.

Note: If you are using Winamp for music and Skype for VoIP, you can adjust Skype settings to automatically pause Winamp on an incoming Skype call. To do so, from Skype click ‘Tools’ Æ ‘Options’ Æ ‘Advanced’ Æ ‘Other’ Æ check the box ‘Automatically pause Winamp during calls’, save and restart Skype.

Reconnecting Audio Streamer with Headset

zTo reconnect Audio Streamer with Headset, simply power on both devices and they will be connected automatically.