Nortel Networks ICS 4.1 Remote access pkgs, Show pkg, Pool pool letter pool, Code Remote

	Page 67
••• Fax Switch	Select whether the Fax detection switch is active or not with the Auto Attendant’s Custom Call
	Routing feature. The default is set to Off.
• Fax DN	Enter the DN of the fax machine that functions with the Auto Attendant’s System Answer or
	Custom Call Routing feature, when the Fax switch detection is active.
• Remote access	In this programming section, you can create a system of controlled access to your Norstar
	system.
•• Remote access pkgs	Create packages to apply to lines that allow or restrict the remote access to Norstar line pools,
	paging, and remote administration.
••• Show pkg:_	Enter the two-digit remote package number (00-15). Package 00 is pre-set to allow no access.
•••• LinePool access	For each package, select whether the user will have access to your system’s line pools.
••••• Pool <pool letter (pool	For each line pool, select whether a remote user can have access.
code)>
•••• Remote page	For each package, select whether a remote user can access the Page feature.
•••• Remote admin	For each package, select whether a remote user can see and change programming.
•••• Remote monitor	For each package, select whether a remote user can monitor the system.
•• Rem line access	Select the remote access packages to be applied.
••• Show line:_	Enter the line number.
•• IRAD	Program a line to be automatically answered by the I-RAD after a set number of rings.
••• Answer line	Any line that is programmed to be manually answered (including target lines), and that is not
	answered by CCR, can be programmed to answered by the I-RAD.
••• After	Select the number of times the line will ring before I-RAD will answer.
• Rec’d # length	Select the number of digits received on auto-answer lines. These digits are used to identify the
	Auto DN and DISA DNs, and to route calls to target lines.
• DN length	Select the length of DNs. DN length can be three to seven digits. Each increase in DN length
	adds the digit “2” to an existing DN (for example: DN 344, increased to five digits becomes
	22344).
• Nat’nl length	The length of the telephone number dialed to reach a person within the same country.
• Make/Break:	Select the Make/Break ratio. The default Make/Break ratio is 40 / 60.
• Release reasons	Release reasons.
• Internal modem	Setting for internal modem when used for remote administration.
• Alarm reporting	Set up the system to automatically transmit alarm codes using the I-RAD.
•• Auto report	Turn automatic alarm reporting on or off.
•• Phone #1	Enter the telephone number the system will dial to transmit an alarm code.
•• Phone #2	Enter an additional telephone number the system will dial to transmit an alarm code.
•• Use line	Enter the number of the line the system will use to transmit an alarm code.
•• Retry time	Enter the length of time in minutes the system will wait before retrying a telephone number used
	for transmitting alarm codes.
•• Num. retries	Select the number of times the system will retry its transmission of an alarm code.
• Hospitality	Hospitality services programming.

P0906186 Issue 02 Compact ICS 4.1 Programming Record