NEC Xen manual General Information, LED Indications

General Information

The following should be considered when reviewing this User Guide:

Instructions are provided for the Xen digital telephones (DTU-type). When using a Ranger Series digital telephone (ETU-type), note that ANS=Answer, TRF=Transfer, SPKR=Speaker, CNF=Conf, FNC=Feature, LNR/SPD=Redial.

All operational instructions assume Prime Line Pickup is assigned to intercom dial tone, Ringing Line Preference is assigned to all telephones, a Call Appearance and Call Arrival key has been assigned to all digital telephones and only a single tenant has been assigned in the system.

All access codes listed are standard; some may vary based on system assignment. Please consult your authorised NEC Dealer for the access codes applicable to your system.

Access to many features is based on system assignments. Not all features may be available from your telephone.

Telephones equipped with displays will provide useful call processing information such as digits dialled, recall indications, feature confirmation, etc. Xen digital telephones (DTU-type) also show features accessible by the soft keys.

LEDIndications

Function	Lamp Status
Line Keys:
Incoming Call	Rapid Flashing Red
Held Call - Your telephone	Slow Flashing Green
Held Call - Other telephone	Slow Flashing Red
Call in progress
Your telephone	Steady Green
Other telephone	Steady Red
Hold recall	Intermittent Flashing Green
Large LED: (360˚ Visual Ring Indicator)
Incoming calls (CO/PBX, DIT	Rapid Flashing Green
or ANA)
Incoming intercom, TIE Line	Rapid Flashing Red
or DID Call
Message from Attendant	Slow Flashing Green
Voice Mail Message	Slow Flashing Red
Feature Key:
DND Set	Intermittent Flashing Red
Call Forward Set	Intermittent Flashing Red
Callback Request	Slow Flashing Red
Intercom LED:
Incoming Call	Flashing Red
Call in progress	Steady Red
Held Call	Flashing Red Conf LED

2