AT&T 1739 user manual Announcement

Feature setup

FEATURE	SYSTEM		OPTIONS
	ANNOUNCE
ANNOUNCEMENT		“Announcement	• Choose ON to listen to the announcement
MONITOR		monitor is…”	when the system answers a call. Choose OFF
			to silence your end of the call. (The callers will
			still hear the announcement.)
			NOTE: Volume must be set to an audible level
			to use the announcement monitor.
NUMBER		“Number	• When this feature is on, the system will
ANNOUNCE		announce is…”	announce the incoming telephone number
(Please see			between the second and third rings.
NOTE below)
			NOTE: When the number announce feature is
			on and ring select is set for two rings, the unit
			will answer after three rings to allow enough
			time for the system to announce the caller’s
			telephone number.
STORE NUMBER		“Store number is…”	• When this feature is on, the system announces
(Please see			the incoming telephone number when it plays
NOTE below)			back a message.
ACCEPT BLOCK		“Accept block	• Choose ON to have the system accept all
CALLS		calls is…”	calls. Choose OFF to have the system respond
(Please see			to blocked calls with the pre-recorded
NOTE below)			announcement, “We’re sorry, blocked calls to
			this number cannot be accepted,” and hang up
			without recording a message.
AUDIBLE MESSAGE		“Message alert is…”	• When this feature is on, the system beeps
ALERT			every 15 seconds when there are new
			messages.

NOTE: For this feature to work, you must subscribe to the caller ID service from your local telephone company. There may be a fee for this service, and it may not be available in all areas.