Fluke 5725A instruction manual Where to Go From Here

5725A

Instruction Manual

1-2. Where to Go From Here

This manual is the operator and service manual for the 5725A. However, because the 5725A operates under the control of the 5700A Calibrator, most operating instructions for the 5725A are in the 5700A/5720A Series II manuals. Topics such as selecting output values, connecting to a UUT (Unit Under Test), and self calibration are covered in the 5700A/5720A Series II Operator Manual. The list below gives some specific pointers, and the text further on describes how to use all the manuals to find 5725A information.

For More Information About:		Refer To:
∙	Unpacking and setup	Section 2 of this manual
∙ Installation and rack mounting		Section 2 of this manual and the
		Y5735/Y5737 Instruction Sheet
∙ AC line power and interface cabling		Section 2 of this manual
∙ Controls, indicators, and binding		Section 3 of this manual
	posts
∙	5725A service information	Sections 4 through 9 of this manual
∙	Operating the amplifier	Section 3 of this manual and Section 4 of
		the 5700A/5720A Series II Operator
		Manual
∙ Cabling to a Unit Under Test		Section 4 of the 5700A/5720A Series II
		Operator Manual
∙	Self calibration	Section 7 of the 5700A/5720A Series II
		Operator Manual
∙	Full verification	Section 3 of the 5700A/5720A Series II
		Service Manual
∙ IEEE-488 or serial remote operation		Section 5 of the 5700A/5720A Series II
		Operator Manual
∙	5700A/5725A specifications	Section 1 of this manual
∙	Theory of operation	Section 4 and 9 of this manual
∙	Troubleshooting	Section 6 of this manual
∙	Ordering a part	Section 8 of this manual

1-4