Black Box manual Placing the Line Share 120H, Bottom of the Line Share 120H

Page 11

LINE SHARE 120H

3.3 Placing the Line Share 120H

The Line Share 120H can be placed on either a flat surface, or mounted on a wall. To mount the Line Share on a wall, follow these steps:

1.Mark the positions for 2 mounting screws (not supplied) on the wall. The positions should be 3-1/4” apart (vertically). Drill the 2 holes, then thread the screws into the wall. The screws should extend 3/16”. Do not over- tighten the screws.

2.Align the keyholes on the back of the Line Share with the 2 screws, then push in and press down to secure it to the wall.

NOTE

If you place the Line Share 120H on a flat surface, do not place it close to any peripheral equipment. Keep it approximately 2 to 3 feet (60 to 90 cm) away from all electronic equipment.

The Line Share 120H can be mounted on the wall with the connected telephone line cords above or below the unit.

Figure 3-2. Bottom of the Line Share 120H.

12

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Line Share 120H Industry Canada FCC StatementLine Share 120H NOM Statement Trademarks Table of Contents Indicators on SpecificationsIntroduction Unpacking the Line Share 120H InstallationPorts on the Line Share 120H Ports on the Line Share 120HBottom of the Line Share 120H Placing the Line Share 120HConnecting the Line Share 120H Single Phone Line/Single Phone Arrangement Configuration for TAD Transfer Feature Disabled Section Installation on a Telephone System Installation on a Telephone System Fax CNG Tones OperationStandard Operations Answering Calls with an Answering Machine Answering Incoming CallsRetrieving Answering-Machine Messages from a Remote Location Receiving a Computer Call Placing an Outbound CallLine Share 120H LED doesn’t light on the Line Share 120H. What should I do? Troubleshooting/Helpful HintsCopyright 1997. Black Box Corporation. All rights reserved
Top Page Image Contents