Binatone 710 manual Installation, Locating the Base unit, Place the Handset on the Base unit

Page 4

2. Installation

1. Locating the Base unit

The Base unit should be placed on a level surface, in a position where:

„the mains adapter plug will reach an easily accessible 230-V AC switch mains supply socket - never try to lengthen the mains power cable.

„the telephone line cable will reach your telephone line socket or extension socket.

„it is not close to a sink, bath or shower, or anywhere else where it might get wet.

„it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, fluorescent lights, etc.

2.Plug the coiled handset cord into the Handset. Plug the other end into

the jack on the left side of the Base unit. Note: The base unit doesn't

require a battery.

3.Place the Handset on the Base unit.

4.Plug the telephone line cord into the PHONE LINE jack at the back of the Base unit. Plug the other end into your telephone line socket

or extension socket.

Always use the telephone line cord supplied with your Spirit 710. Other telephone line cords may not work.

Make sure the plugs click into place.

5.Plug the power supply cord into the POWER jack at the back of the Base unit. Plug

the other end to a 230V AC, 50Hz mains socket, with the switch on the socket set to OFF

6.Switch ON the mains power at the socket. Wait while the

display shows INITIALISATION, then the announcement

Answering machine on. Announcement onebefore

the display changes to the standby screen.

7.Lift the Handset and check for Dial tone in the earpiece.

The Spirit 710 Base unit must be used

only with the supplied mains adapter. Using any other adapter may damage the unit.

4

Image 4
Contents Spirit Microphone For EXIT/ Answer ON/OFFEntry with Installation Locating the Base unitPlace the Handset on the Base unit Or extension socketDesk/Wall mount installation Desk Mount Wall MountDesk/Wall mounting continue SET LanguageSET Time DateSET Flash Setting up continueTime Press Menu button to confirm the Message Length setting LCD Contrast Message Length Rings to AnswerRemote Access TAM HD 1 ON/OFF setting Ringer volume To make a CallTelephone Operation Dial the telephone numberOne Touch Memory Telephone operation continueOutgoing call record One Touch Memory Operation ContinueDial out Stored memory Number OutgoingPhonebook Outgoing call record continueStoring an Outgoing Call record Into Phonebook MemoryTo add a Phonebook continueNew record Press the Phonebook button to save the edited record Caller Display operation To delete a Record from MemoryCaller Display operation continue Press and hold the Delete button Press the Delete buttonPress the Delete button to confirm Answering Machine system MessagesOGM To play the currentAnswering Machine System continue To playback your message/s To record a memoPlayback 1 and Pause EXIT/ON-OFF button During message playback, press the Delete buttonTo delete all 1 messages To go back to the default Remote operationTo check Your RemoteRemote operation continue To checkFrom a RemoteUsing Switching On fromInstruction CodeOperational notes Electrical safety„ Never use your Spirit 710 outdoors during a thunderstorm Troubleshooting Troubleshooting continue If the fault persists … Technical details Declaration of conformityContents of this User Guide 0845 345