Avaya 3600 manual Modes of Operation, Active Mode, To make a call Press Start Call

Page 12

Modes of Operation

Modes of Operation

Active Mode

Unless otherwise stated, the following information assumes your wireless phone is in standby mode.

To make a call:

1.Press Start Call.

This transitions your phone to active off-hook mode and a dial tone is heard. The phone is in communication with the IP Office and in the Main Display area, Dial is displayed.

2.In certain PBX integrations, some features are designed to be accessed from an active on-hook mode. To go on-hook while still active, press Line.

3.When you have completed the call, press End Call to exit the active mode and return to the standby mode.

Notes

The phone is also in active mode when you receive a call.

When your phone is in active mode, whether off-hook or not, it requires the most bandwidth of any mode. To conserve bandwidth and battery power, when you have completed a call or have finished accessing active mode menus and features, press End Call to return to standby mode.

Modes of Operation

The wireless phones uses different amounts of power and bandwidth in different modes of operation. Bandwidth is provided by access points located throughout your facility. Bandwidth availability varies by type of access point. The battery pack in your phone provides approximately four hours of talk time or 80 hours in standby mode.

If Push-to-Talk (3626 phone only) is allowed and enabled, standby battery pack life is decreased to approximately 30 hours. See Push-to-Talk.

Note

Conservation of battery life and bandwidth is possible when you understand the modes and use them appropriately.

3600 Series Wireless User Guide	Page 8
IP Office	[15-601104] Issue [1] (1 June 2006)

Image 12

Contents IP Office Table Of Contents Table Of Contents IiiPage Series Wireless User Guide IP Office Issue 1 1 June CopyrightWireless Phone About this GuideImportant Information about your Phone Overview3616/3620 Wireless Phone Power On/Start Call Power Off/End CallBattery Select3626 Wireless Phone Push-to-Talk Radio Control Active Mode Modes of OperationModes of Operation To make a call Press Start CallPush-to-Talk Mode Standby ModeBasic Operation Turning the Phone On/OffAnswering Calls System Feature Activation Making CallsLocking/Unlocking your Phone Volume Settings To change the speaker volume whilst on a callVoicemail To silence your ringing phoneUsing the Softkeys ConfHold MuteTransfer ConferenceHold MuteSetting User Preferences User PreferencesDefault setting Navigate Lock KeysRing Options To unlock the keypadTelephone Ring Noise Mode Phone OptionsAuxiliary Ring 1 Key TonesSystem Information ExtensionKeypad Autolock To select the volume level Push to TalkPush to Talk Overview Using Push to Talk PTT To change the PTT volumeTo initiate a call To initiate subsequent transmissionsTo mute a PTT call To terminate incoming broadcastsTo answer an incoming PBX call during a PTT call To make a PBX call during a PTT callBattery Packs Important Information on your Battery Packs and ChargersBattery Pack Removal and Replacement Low Battery Indication ChargersDesktop Chargers Phone in DCE100 Desktop ChargerDual Chargers To charge your phone with a desktop chargerPhone in DCE200 Dual Charger Indicator Light To charge your phone with a dual chargerTo remove, charge and replace the 3620 battery pack Quad ChargersCleaning your Phone and Chargers General CareGeneral Care of your Phone and Chargers Regulatory Information Declaration of ConformityRadio Frequency Information Operational WarningsElectromagnetic Interference/Compatibility FacilitiesMedical Devices Use While DrivingInternational Certifications Z233Specific Absorption Rate Information Cleaning IndexAL7 1LZ