EXIT/NORMAL (display feature)
When you are ready to leave Display or Softkey Mode and return to Normal
1Press [ Exit ].
HOLD
To put a call on hold
1Press [ Hold ].
To answer a new call while active on another
1Press [ Hold ].
2Press call appearance button of incoming call.
To return to held call
1Press call appearance button of held call.
INSPECT (display feature)
To see who is calling while on a call
1Press [ Inspect ].
● Call source is shown on display.
2Press [ Exit ] to return to display for present call.
LAST NUMBER DIALED
To automatically redial the last number you dialed
1 Press [ LastDialed ] |
|
or Dial Last Number Dialed access code | . |
LEAVE WORD CALLING (LWC)
To leave a message after dialing an extension
1Press softkey below LWC
or Press [ LWC ] before hanging up your handset.
To leave a msssage without ringing an extension
1While
| or Dial Leave Word Calling access code | . | |
2 | Dial extension. |
|
|
3 | Hang up. |
|
|
To cancel a Leave Word Calling message
1While
| or Press [ Cancel LWC ] |
|
| . | ||||
2 | or Dial Leave Word Calling cancel code |
|
|
| ||||
Dial extension. |
|
|
| |||||
|
|
|
|
|
|
|
| |
| PRIORITY CALLING |
|
|
| ||||
|
|
|
|
|
|
| ||
To place a priority call |
|
|
| |||||
1 | While |
|
|
| ||||
| or Press [ Priority ] | . |
|
| ||||
|
|
|
|
|
|
|
| |
| or Dial Priority Calling access code |
|
|
|
| |||
2 | Dial extension. |
|
|
|
RESET SPEAKERPHONE
To adjust the speakerphone to the surrounding room acoustics
1While
●You hear a series of tones.
SELECT RING (and RINGER VOLUME)
To select a personalized ring
1Press [ Shift ] and then press [ Hold ].
●Current ringing pattern plays, and pattern number is displayed.
2To cycle through all eight ring patterns, continue to press (and then release) [ Hold ] (or press
[ N e x t > ] or [ < P r e v ]). |
3When you hear the desired ring pattern, press [ Shift ] again.
To adjust ringer volume if necessary (speaker is not active)
1To raise the volume, press the right half of the Volume control button labeled [ ∧ ];
to lower the volume, press the left half of the Volume control button labeled [ ∨ ]
SEND ALL CALLS
To send all calls (except priority calls) immediately to coverage
1 Press [ Send Calls ] | . |
or Dial Send All Calls access code |
To cancel Send All Calls
1While
or Dial Send All Calls access code |
| . |
SPEAKERPHONE
NOTE: To use this feature, your voice terminal must be set for the Speakerphone (speak and listen) feature.
To place or answer a call without lifting the handset, or to use speakerphone with any feature
1Press [ Speaker ].
2Place or answer call, or access selected feature.
3Adjust speakerphone volume if necessary:
To raise the volume, press the right half of the Volume control button labeled [ ∧ ];
to lower the volume, press the left half of the Volume control button labeled [ ∨ ].
To prevent the other party from hearing you
1Press [ Mute ].
●Red Mute light goes on.
2Press [ Mute ] again to resume talking to party. ● Red Mute light goes off.
7 | 8 |
6 |
|