AT&T TL-210 WH user manual TABLE/DESK Installation, Connect handset to base, Check for dial tone

Page 2
Figure 1
Figure 2

TABLE/DESK INSTALLATION

This telephone includes a 7-foot line cord with a modular plug on each end. Use this cord to connect the telephone to a modular jack.

1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location.

Reinstall the card and clear plastic cover.

2 Connect line cord to telephone Plug the long line cord into the jack on the underside of the telephone base. Then feed the line cord through the channel provided so the telephone sits flat on your table or desk during use (Figure 1).

3 Connect line cord to wall jack Plug free end of the line cord into a modular jack. Make sure it snaps firmly into place.

4 Set DIAL mode switch

This product comes set in the tone (TT) mode. Make sure

you choose the correct dialing method (TT or DP); touch tone dialing will not work if you have dial pulse service.

5Connect handset to base

Plug one end of the coiled handset cord into the handset, and the other end into the base. Then hang up.

6Check for dial tone

Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.

TO DISCONNECT the telephone, squeeze the clip on the modular plug and pull it out of the jack.

1

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Trimline Check for dial tone TABLE/DESK InstallationConnect handset to base Reverse handset tab Wall InstallationFill in directory card Install telephone base on wall jack Hold the base up Connect handset to telephoneErasing Redial OperationRedial FlashMute Ringer VolumeReceiver Handset Volume Select Ringer ToneTemporary Tone Dialing Memory Features Memory DialingTo dial One-Touch DialingTo program numbers into memory Speed Dialing Memory EraseCase of Difficulty No Dial ToneTelephone Does Not Ring
Top Page Image Contents