AT&T TL-210 WH Install telephone base on wall jack Hold the base up, Connect handset to telephone

Page 4

4Install telephone base on wall jack Hold the base up

next to the wall jack, and plug in the line cord (Figure 3). Then push the base against the wall jack and down until it is held securely by the mounting studs.

NOTE: If you cannot fit the base

onto the wall jack,

remove the four Figure 3 non-slip pads.

1 MEM

2 MEM

3 MEM

4 MEM

5 MEM

MEM

MEM

MEM

MEM

THIS

6

7

8

9

. NO

5Set DIAL mode switch

Refer to Step 4 in “Table/Desk Installation.”

6Connect handset to telephone

Connect one end of the coiled handset cord into the base. Plug the other end into the handset (Figure 4). Then hang up.

2 MEM

3 MEM

4 MEM

5 MEM

M

9 MEM

. NO THIS

Figure 4

7Check for dial tone

Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.

3

Image 4
Contents Trimline Connect handset to base TABLE/DESK InstallationCheck for dial tone Fill in directory card Wall InstallationReverse handset tab Install telephone base on wall jack Hold the base up Connect handset to telephoneOperation RedialErasing Redial FlashRinger Volume Receiver Handset VolumeMute Select Ringer ToneTemporary Tone Dialing Memory Features Memory DialingTo program numbers into memory One-Touch DialingTo dial Speed Dialing Memory EraseCase of Difficulty No Dial ToneTelephone Does Not Ring