AT&T 915 user manual Reverse the handset tab

Page 9

Installation

2.Set the tone/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the switch to DP (pulse).

3.Connect the short line cord to the telephone. Plug the line cord into the jack labeled TELEPHONE LINE and thread the cord through the tabs under the phone as shown.

Modular telephone wall jack

Tone/pulse switch

Telephone line cord

4.Reverse the handset tab.

This tab holds the handset when you hang up. Hold down the switchhook, and slide the tab up and out of its slot. Turn the tab so that the end with the hook is up. Then hold down the switchhook while you insert the tab back into its slot.

Switchhook

Handset tab

6

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Big button telephone Or call 1 800 Contents Parts list Before you beginBefore you begin Installation InstallationTable/desk installation Connect the handset to the telephone Check for dial tone Wall installation Reverse the handset tab Connect the handset to the telephone Telephone operation Telephone operationMake a call End a callFlash RedialHandset volume Ringer volumeTemporary tone dialing Telephone memory Telephone memoryDirectory card Store a number in memoryDial a number in one-touch memory Store a pause in a memory numberDial a number in two-touch memory Erase a memory numberGeneral product care General product careTechnical specifications Technical specificationsCase of difficulty Case of difficultyNo dial tone Telephone doesProblem Problem SolutionIndex Index
Top Page Image Contents