AT&T 915 user manual Connect the handset to the telephone

Page 10

5.Connect the handset to the telephone.

Plug the coiled cord into the handset jack on the left side of the base unit. Plug the other end of the coiled cord into the handset, then hang up.

6.Connect the line cord to a modular wall jack and mount the phone on the wall jack as shown.

Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely.

7.Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, slide the VOLUME switch to the right. If you still do not hear a dial tone, see the In case of difficulty section beginning on page 15 of this user’s manual.

Installation

7

Image 10
Contents Big button telephone Or call 1 800 Contents Before you begin Parts listBefore you begin Installation InstallationTable/desk installation Connect the handset to the telephone Check for dial tone Wall installation Reverse the handset tab Connect the handset to the telephone Make a call Telephone operationTelephone operation End a callRedial FlashRinger volume Handset volumeTemporary tone dialing Directory card Telephone memoryTelephone memory Store a number in memoryDial a number in two-touch memory Store a pause in a memory numberDial a number in one-touch memory Erase a memory numberGeneral product care General product careTechnical specifications Technical specificationsNo dial tone Case of difficultyCase of difficulty Telephone doesProblem Solution ProblemIndex Index