5.Configuring the IRIS Touch Dialer
The majority of configurations can be carried out via the touch screen interface display on the IRIS dialer. For more complex systems, for example where the data port is used, additional configuration is available via the USB connector using a laptop / PC and IRIS dialer configuration software (available via the Chiron website).
The touch screen display on the IRIS dialer provides an Installation Wizard which guides you through a set of instructions for configuring the dialer. It is recommended that you use this Wizard as it automatically carries out tests as you proceed through the configuration.
Note: To select an option on the screen, touch the screen display.
Use the following procedure to configure the IRIS Touch Dialer:
1.Plug the power cable into the battery backed supply of the alarm panel. The cable with the white stripe is the
The dialer carries out a self test and the Welcome screen then displays.
Note: If the power has been connected for the first time the Language menu displays. Select the appropriate language from the list of languages available.
2.Select the Installer Menu option from the Welcome screen.
3.Select the Installation Wizard option from the Installation Menu.
4.Follow the remaining instructions on the screen to complete the configuration.
Once the installation is completed successfully the message Status - System OK is displayed on the Welcome screen and the LED Indicator on the top of the unit [17] is on steady.
5.Carry out all the standard alarm signaling tests appropriate for the alarm system.
6.Push up the slider to cover the touch screen.
Iris Touch 200 Range Dialer Installation Manual | 7 |