2.Before you start…
2.1.Package contents
In this package you should have the following components:
•Main dialer unit comprising:
•PCB with 3 part plastic enclosure (back, front and slider).
•4 x assembly screws.
•2 x tamper switch springs.
•Power cable (black) for connection to DC supply.
•Ethernet cable (cream) for connection to IP network. (Ethernet / Ethernet & GPRS only).
•Antenna for GSM/GPRS. (GSM / Ethernet & GPRS only).
•Dialer cable (grey) for connection to dialer output of alarm panel.
•Screws and plugs (3 of each) for wall mounting.
•Sense resistor (18K ohm) for alarm dialer cable fault/tamper detection.
•Installation manual.
2.2.Pre-requisites
For installations using IP (Ethernet) or GPRS you must ensure you have the following:
•The IP address for the Monitoring Centre.
•Confirmation that the Monitoring Centre is set up and ready for the account number or name to be used for this IRIS dialer.
•The type of IP address (either automatic or fixed) for the installation site. If the site has a fixed IP address, you should get this information from the customer in advance, together with the Gateway Address and the Subnet Mask for the IRIS dialer.
•An additional long Ethernet cable, in case the installation site requires one longer than that supplied with the IRIS dialer.
•A SIM card enabled for GPRS with the PIN code clear. (Ethernet & GPRS only.)
•The GPRS Access Point Name (APN) of the SIM card provider. Some networks also require a User Name and Password which can also be obtained from the SIM card provider. (Ethernet & GPRS only.)
Iris Touch 200 Range Dialer Installation Manual | 3 |