IRIS 200 installation manual Appendix a Settings menu, Setting Purpose

Appendix A – Settings menu

Setting	Purpose
Network Interfaces	Selects which network interfaces are going to be used (i.e.
	Ethernet and/or Ethernet/GPRS). Stops dialer reporting trouble
	on interfaces not being used.
Account Number/Name	The IRIS account number/name, as allocated by the Monitoring
	Centre.
Monitoring Centre IP	IP address of the receiver at the Monitoring Centre.
Address
Dialer IP Address	IP address of the dialer, i.e. either automatic (DHCP) or fixed.
GPRS Settings	GPRS Access Point Name (APN), user name and password.
	View signal strength.
Alarm Panel Interface	Selects whether or not the 2-wire cable to the dialer is
	monitored for short and open circuit.
	Note: For monitoring to function correctly a sense resistor must
	be fitted as described earlier in this manual.
Pin Inputs	Selects whether or not pin input is monitored (using sense
	resistors) and selects input function:
	•	Send SMS message.
	•	Send SIA format alarm over IP (trouble and restore
		event codes and zone number).
	•	Send Fast Format alarm over IP (alarm or
		open/close) and set pin polarity.
Relay Outputs	Activation of relay outputs by incoming SMS messages.
Trouble Reporting	Selects how local communications problems are reported, via:
	•	Relay outputs.
	•	SMS.
	Sets the text string that appears on screen to advise the user
	what action to take (e.g. support centre telephone number).
	Sets IP address of support centre for remote diagnostics.
Language	Selects language.
Installer Password	Sets a password to the Installer menus, if required.
Contrast	Sets display contrast.
Tamper restore	Clears tamper alarm if tamper switches have been triggered.
Audio	The dialer has a diagnostic tool with integral speaker to allow
	the audio signal to and from the alarm dialer to be heard. The
	audio can be switched on and off.
Default all	Sets all settings back to factory defaults.

Iris Touch 200 Range Dialer Installation Manual 11