Link electronic Door phone manual Max. time sec between button presses range, 15 ∗

d– maximum time in minutes for which a call may last. This time can be extended during a call by dialling Prolong Call digit from telephone (∗ or #). Time setting is per table.

Parameter	Value	Description	Default	Exam.1	Exam.2
53	w	time between button	2	2	2
		presses
w – max. time [sec] between button presses [range 1-9]

time	choice
[min]
0,5	0
1 - 9	1 - 9

15∗

30#

-relay closing – if time between two next presses is bigger than w time, the code is not evaluated correctly.

-dialling – if the button pressed is the first password number for switch closing, so the choice is delayed by this w time.

Parameter	Value	Description	Default	Exam.1	Exam.2
54	z	On hook time before new	2	2	2
		call

z– time [sec] for which the unit will hang up, before repeat dialling (button pressing during call or dialling, busy tone detection) [range 1-5]

Parameter	Value	Description	Default	Exam.1	Exam.2
55	z	Call start time	1	1	1

z– time [sec] after unit goes on hook before dialling [range 1-5]. This time is different for each PBX, but most PBXs usually manage to process dialling up to 2 seconds after line on hook.

Parameter	Value	Description	Default	Exam.1	Exam.2
56	h	Number of rings before	12	12	12
		hanging up or group mode
		switching

h – specifies the amount of time spent ringing before the unit hangs up and tries the next number.

Parameter	Value	Description	Default	Exam.1	Exam.2
57	t	DTMF tone duration (ms)	5	5	5
			(100ms)	(100ms)	(100ms)
58	m	Space duration between	5	5	5
		DTMF tones (ms)	(100ms)	(100ms)	(100ms)
59	f	Recall duration (ms)	1	1	1
			(100ms)	(100ms)	(100ms)
50	p	Pause duration (ms)	8	8	8
			(800ms)	(800ms)	(800ms)

t– DTMF tone duration is determined by the formula: (entered number + 5) x 10 = tone duration [ms]

[range 1-0 i.e. 60-150ms]

m– Space duration between DTMF tones is determined by the formula:

(entered number + 5) x 10 = gap duration [ms]

[range 1-0 i.e. 60-150ms]

f– Recall duration is determined by the formula: entered number x 100 = Recall duration [ms]

[range 1-6 i.e. 100-600ms]

p– Pause duration is determined by the formula: entered number x 100 = pause duration [ms]

[range 5-0 i.e. 500-1000ms]

13