Beltpack Set-up
Battery Installation
Ensure that the On/Off volume control knob is turned off. Press down and hold down the battery release latch, slide the battery pack about 1/8 inch back, toward the latch, until it stops. Then lift battery pack out. Replace batteries as follows:
1. Open the battery pack by inserting finger nail and lifting.
2.Pull battery strap to remove low or dead batteries.
3. Load new batteries following the polarity as shown in battery case
4. Start loading at the end of the case where
the strap is attached to the case.
5. Be sure strap goes under batteries. | WARNING |
| |
6. Tuck end of strap under door | Do not place an alkaline TR battery |
pack in any battery charger. Severe | |
when placing the battery cover | charger and battery pack damage |
back on the case. | may result. |
Figure 29