RCA 14, 25413 manual Line 1 + Line 3 +

Page 7

Connections & Setup

4. Connect the telephone line cords:

If you have two dual line wall jacks installed in your home or office, plug one end of the straight telephone line cord tagged as “LINE 1+2” into the jack marked LINE 1 + 2 and one end of the other straight line cord into the other jack on the back of the base. Plug the other end of each line cord into the dual-line wall jacks.

LINE 1 + 2

LINE 3 + 4

If you have four single-line wall jacks installed in your home or office, you must use adaptors/couplers (not included) to combine the four single telephone lines into two dual lines. The adaptor/coupler may look similar to the one pictured here and can be purchased from your local telephone products retailer.

Adaptor/coupler LINE 1 + 2

Adaptor/coupler LINE 3 + 4

NOTE: To use four lines, you must have four telephone lines with unique telephone numbers. If you only have one telephone line, this phone will still operate, but only as a single line telephone.

Unit Initialization:

After you connect the power supply and Line 1 to the unit, the system automatically searches for and sets up a phone ID. To set your own Phone ID, or change your phone ID, follow the steps in the Phone ID section.

You may connect up to 16 RCA 25403, 25404, 25415, 25413 and/or RCA 25414 phones to the system at one time. Features like intercom, page and call transfer may be used among the units, but Line 1 must be common for all 25414 or 25413 units for these features to work properly. You may choose to share or privatize lines 2, 3 and 4.

5.Connect the handset cord:

Connect one end of the coiled handset cord to the jack on the side of the base and the other end into the jack in the handset, and place the handset in the cradle.

6.Check for a dial tone:

Lift the handset and listen for a dial tone. If you hear a dial tone, the phone is properly installed.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Model 25413/14 Notification to the Local Telephone Company Important InformationEquipment Approval Information Interference InformationLicensing FCC RF Radiation Exposure StatementHearing Aid Compatibility Table of Contents Base Layout Connections & SetupParts Checklist Telephone Jack RequirementsImportant Installation Guidelines Important Installation InformationInstalling the Phone Line 1 + Line 3 + Programming the Telephone Data PortSystem Verification Other System PhonesPhone Name Delay RingPriority Line Phone IDNo Unknown/Blocked Not applicable to model Intercom Auto AnswerFlash Time Call Alert ToneRegional Area Codes Not applicable to model Manually Setting the Time and DateDisplay Contrast Local Area Code Not applicable to modelBasic Operation OperationAnswering Calls Switching Between the Speakerphone, Handset, and HeadsetMaking Calls with the Optional Headset Pre-dialingReviewing the Redial Numbers HoldFlash RedialConference Calls VolumeIntercom Calls PrivacyCaller ID CID Receiving and Storing CID Records Caller IDIf You Programmed Your Local Area Code If You Did Not Program Your Local Area CodeCall Waiting Caller ID MemoryMemory Log and Phone Book Directory Memory Memory Delete/Clear Storing the Last Number DialedStoring a Pause in Memory Dialing a Stored NumberOther Information General Product Care ServiceFor how long after your purchase Limited WarrantyAccessory Information Accessory InformationIndex
Top Page Image Contents