RCA 25413, 14 manual Important Installation Information, Important Installation Guidelines

Page 6

Connections & Setup

Important Installation Information

Never install telephone wiring during a lightning storm.

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch non-insulated telephone wires or terminals, unless the telephone line is disconnected from the network.

Use caution when installing or modifying telephone lines.

Temporarily disconnect any equipment connected to the phone such as faxes, other phones, or modems.

Important Installation Guidelines

Install telephone near both a telephone (modular) jack and an electrical power outlet.

Avoid sources of noise, such as a window by a busy street, and electrical noise, such as motors, microwave ovens, and fluorescent lighting.

Avoid heat sources, such as heating air ducts, heating appliances, radiators, and direct sunlight.

Avoid areas of excessive moisture or extremely low temperature.

Avoid dusty locations.

Avoid other cordless telephones or personal computers.

CAUTION: Always disconnect all phone cords from the base unit before battery installation or replacement.

Installing the Phone

The phone may be connected to two 2-line (RJ14C) wall jacks or four single line (RJ11C) wall jacks to accomodate all four lines.

1.Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed on a level surface, such as a table top or desk.

2.Install 4 AAA-size alkaline batteries (not included) for back up power in the event of a power failure.

Use a screwdriver to loosen and lift up the battery compartment door located on the bottom of the phone.

Insert the batteries as shown on the diagram inside the battery compartment.

Snap the battery compartment door back into place and tighten the screw.

NOTE: If the low battery icon appears in the display, you need to replace the batteries. It is important that you replace them as soon as possible to maintain unit operation when electrical power is off. As a precaution, you may want to write down any stored information you do not want erased.

IMPORTANT: If you are not going to use the telephone for more than 30 days, remove the batteries because they can leak and damage the unit.

3. Plug the AC power adaptor cord into an electrical outlet and the DC connector into the back of the base.

CAUTION: Use only the ATLINKS USA 5-2651 power adaptor that is compatible with this unit. Using other power adaptors may damage the unit.

6

Image 6
Contents Model 25413/14 Interference Information Important InformationEquipment Approval Information Notification to the Local Telephone CompanyFCC RF Radiation Exposure Statement LicensingHearing Aid Compatibility Table of Contents Telephone Jack Requirements Connections & SetupParts Checklist Base LayoutImportant Installation Information Important Installation GuidelinesInstalling the Phone Line 1 + Line 3 + Other System Phones Data PortSystem Verification Programming the TelephonePhone ID Delay RingPriority Line Phone NameCall Alert Tone Intercom Auto AnswerFlash Time No Unknown/Blocked Not applicable to modelLocal Area Code Not applicable to model Manually Setting the Time and DateDisplay Contrast Regional Area Codes Not applicable to modelOperation Basic OperationPre-dialing Switching Between the Speakerphone, Handset, and HeadsetMaking Calls with the Optional Headset Answering CallsRedial HoldFlash Reviewing the Redial NumbersPrivacy VolumeIntercom Calls Conference CallsCaller ID CID If You Did Not Program Your Local Area Code Caller IDIf You Programmed Your Local Area Code Receiving and Storing CID RecordsMemory Call Waiting Caller IDMemory Log and Phone Book Directory Memory Dialing a Stored Number Storing the Last Number DialedStoring a Pause in Memory Memory Delete/ClearOther Information Service General Product CareLimited Warranty For how long after your purchaseAccessory Information Accessory InformationIndex