Quadra-Fire SAPPHIRE-MBK Existing Masonry Chimney, Type A, Type C - Up & Out Installation, Type B

4. Existing Masonry Chimney
Type A		Type B
		Chimney Liner
	Termination Cap

3 in. (76mm)

Flex Liner

Co-Axial to

Co-Linear ConnectorCo-Axial to Co-Linear Connector

Pipe Length	Pipe Length
(Optional)
	Optional

Showing (2)

30 ft. (9m)

Sections of

Flex Liner

Chimney Liner

Termination Cap

30 ft. (9m) of 3 in. (76mm) Flex Liner Exhaust Section

(Cut to length)

This section of the chimney must be sealed

The chimney must be sealed from the 4 ft. (1m) section to termination using a smoke shelf or a flue restrictor.

The seal should be 6 in. (152mm) below the end of the 4 ft. (1m) Air Intake section.

4 ft. (1m) of 3 in. (76mm) Flex

Liner Air Intake Section

Type A & B Co-Axial to Co-Linear

Type C - Up & Out Installation

Type D - Hearth Mount

Termination Cap

Top Adaptor Flashing

4 in. (102mm)

Flex Liner

Retro Connector

90° Elbow

Direct Vent

Alcove Clearance to Combustibles must be maintained.

Chimney Liner

Termination Cap

30 ft. (9m) of 3 in. (76mm)

Flex Liner Exhaust Section (Cut to length)

This section of the chimney must be sealed

Chimney must be sealed from 4 ft. (1m) section to termination using a smoke shelf or a flue restrictor. Seal should be 6 in. (152mm) below end of 4 ft. (1m) Air Intake section.

Pipe

	4 ft. (1m) of 3 in. (76mm) Flex
Co-Axial to Co-Linear Connector	Liner Air Intake Section

Figure 5.25

20 Quadra-Fire • Sapphire • 7055-116 Rev. D • 6/11