Linear VMC-1 manual PRE-DRYWALL Color Video Door Station, POST-DRYWALL Color Video Door Station

Page 14

Door Station Rough-In

VMC1VDS-S/BZ Door Station Rough-in

VMC1HR Rough-in Enclosure

The VMC1VDS-S and VMC1VDS-BZ incorporate a wide angle 120 degree horizontal viewing camera into a Door Station. It is normally mounted at a height from the floor of: 55” – 60”. Installation of this unit on an exterior wall requires 4 screws and anchors (See Figure 6). When installing these units, be aware of the camera location and the direction of sunlight and other ambient light. Direct sun or light pointed into the lens of the VMC1VDS camera may impact video quality. Additionally, exposure to extreme weather conditions is not recommended. For added protection against weather, the VMC1VDS-S and VMC1VDS-BZ should be equipped with a DSWS weather shield. The installation of the DSWS is provided in the VMC1 Finish Out Guide.

1.Attach the VMC1HR flush to the exterior wall using the two inner pre-punched holes in the VMC1HR.The outside holes on the wings of the box are to be used to mount the VMC1VDS-S/BZ and not to be used to attach the VMC1HR to the exterior wall.

2.Pull the Cat-5 wires through the hole in the back of the VMC1HR and loop it through so they do not fall back into the wall.

3.If the door strike or Chime activated Control Output is to be utilized, see “Door Release Rough-in and “Chime Activated CO Rough-in

PRE-DRYWALL COLOR VIDEO DOOR STATION

USE INNER HOLES FOR

MOUNTING ROUGH-IN

ENCLOSURE TO STUD

VMC1VDS-BZ

VMC1VDS-S

7-3/4”

VMC1HR

3-1/2”

CAT5 CABLE LOOPED

WITH EXCESS AMOUNT

BEZEL

COLOR VIDEO DOOR

STATION WALL

MOUNTING PLATE

ELECTRONICS

PANEL

VMC1VDS-BZ

VMC1VDS-S

DRYWALL

GRILLE

ANCHORS

POST-DRYWALL COLOR VIDEO DOOR STATION

Figure 5. VMC1VDS-S/BZ Door Station Rough-In

12

Image 14
Contents VMC1 Shock Hazard Important DO’S & DON’TS Table of Contents Block Diagram Introduction Rough-in KitMaterials Required ToolsOverview Maximum Length for Cable Runs Wiring InformationCables and Wiring Cable Type and ConfigurationVMC1MB Master Station Mounting Bracket VMC1MB Installation Unfinished WallMaster Station Rough-In VMC1MB Installation Finished Wall VMC1MBRoom Station Rough-In Room Station Installation Unfinished WallRoom Station Installation Finished Wall Room Station MountingDoor Station Rough-In VMC1VDS Door Station Rough-inPRE-DRYWALL Color Video Door Station POST-DRYWALL Color Video Door StationPower Supply Connections Power Supply Rough-InTE6D Power Supply PRE-WIRED Self Contained TE6D Power SupplyPower Supply Wiring Power Identification AT Master StationH628 Data Hub Data Hub WiringPull Wires AM Antenna Antenna InstallationRadio Antennas FM AntennaChime Activated Control Output Rough-In Auxiliary Output Rough-InDoor Release Rough-in VMC1VDS DRWAppendix a Available Components Appendix a Available Components MLTL2DN49IR For more parts and accessories, please go to Year Limited Warranty