Aiphone IS Fasten the unit to Mounting surface, Is-Dvf, Install the back box in the wall

■Mounting

IS-DV (surface-mount)

1 Loosen the screw with the special screwdriver, and remove the front panel.

Loosen

Special screwdriver (included)

4 Fasten the unit to the	NOTE
mounting surface.	Make room for threading a screw.

*	Use board anchors or concrete	Screw mounting
	plugs as needed.				Unit center
		hole x 4
	Anchor x 4
	(included)	Ø 6 mm	35 mm		11/16'')-
Vandal-resistant		(Ø 1/4")	(1-3/8")
front panel			Unit		(7
	Option wires		center	(3-9/16")	194 mm
		Mounting height
				mm
		GL=1,500 mm (5')
				90
	CAT5e/6 cable
					25 mm (1")
			25 mm (1")
					81 mm (3-1/4'')

The unit

Screw (for wall-mounting) × 4 (included)

Water escape holes Do not block the holes.

3 Open the terminal cover, and connect the CAT5e/6 cable and option wires to the unit.

Tighten

5 Attach the front panel to the unit by hanging the upper 2 parts on the unit.

*Tighten the screw with the lower part of the front panel pressed to the wall.

2 Insert the transparent name plate. (IS-DV and IS-DVF)

1Peel off the protective seals on the plate (both sides).

2Fill in the name on the transparent name plate.

Be sure to leave 25 mm (1") of white space on the right end to account for insertion.

3Insert the filled-in transparent name plate at the

specified insertion opening (indicated with	in
diagram).

To

insertion opening

25 mm (1")

To insertion opening ABCDEFG

2 mm (1/8")

IS-DVF (flush-mount), IS-SS (flush-mount)

e.g.) IS-DVF

Flush mount back box (included)	120 mm
	(4-3/4'')

Vandal-resistant front panel with the unit attached

Loosen

Special screwdriver

(included)Tighten

Special screw x 4 (included)

	1 Install the back box in the wall, and
235 mm	then connect the CAT5e/6 cable
(9-5/16'')	and option wires to the unit with the
	terminal cover open.

Mounting height (box center)

GL=1,500 mm (5')

45 mm (1-13/16'')

Transparent name plate

3 Fasten the front panel to the back box with the special screws.

2 Insert the transparent name plate. (IS-DVF only)

*See above for details.

21