8Using more of your Philips Tapster Bluetooth stereo headset
8.1Learn about the battery status
Immediately after turning the headset on, the LED will indicate the battery status.
LED behaviour |
| Battery status |
3x red blinking |
| Less than 25% of charge |
| ||
|
| remaining |
|
|
|
2x red blinking |
| Less than 50% of charge |
|
| remaining |
|
|
|
1x blue blinking |
| 50% or more of charge |
|
| remaining |
|
|
|
Approximately five minutes before the battery runs out you will hear two short beeps every minute to remind you to end the call or transfer it to your phone before the battery runs out. The LED will also continuously flash red with about five minutes of talk time remaining.
8.2Learn about simultaneous use for voice and audio
Your Bluetooth stereo headset can connect to one Bluetooth audio source (supporting the A2DP and AVRCP Bluetooth profile) and one Bluetooth communication source (supporting HFP or HSP Bluetooth profile) at the same time.
Therefore you can connect your Bluetooth stereo headset
•with a Bluetooth stereo enabled phone to both listen to music and lead calls, or
•with a Bluetooth phone that only supports Bluetooth communication (i.e. does not support Bluetooth stereo (A2DP)) to lead calls and at the same time to a Bluetooth stereo device (Bluetooth enabled MP3 player, Bluetooth audio adapter etc.) to listen to music. Make sure to pair the phone first with your Bluetooth headset, then turn both the phone and headset off to then pair the Bluetooth audio device.
With the SwitchStream feature you can listen to music and monitor your calls at the same time. While listening to music, you will hear a ring tone when receiving a call and can switch to the call simply by tapping the earpiece.
16