2.5Notice for USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/ TV technician for help.
Warning
Changes or modifications made to this equipment not expressly approved by Philips may void the FCC authorization to operate this equipment.
IMPORTANT NOTE:
FCC / IC Radiation Exposure Statement: This equipment complies with FCC / IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be
Address for Philips accessories service center:
Philips accessories and computer peripherals Ledgewood
NJ 07852 USA
2.6Notice for Canada
Operation is subject to the following two conditions:
1This device may not cause interference and
2This device must accept any interference, including interference that may cause undesired operation of the device.The term “IC:” before the certification / registration number only signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment.
2.7Trademarks
Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners.The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Koninklijke Philips Electronics N.V. is under license.Tapster, EverClear
and FullSound are trademarks belonging to Koninklijke Philips Electronics N.V.